Air Rifle Target Trap, Airgun Target Stop, Rugged Pellet Gun Trap

Description

This is a Used very rugged steel pellet gun trap I made a long time ago. The frame is 5" X 5" box tubing and is 5/16" thick. The 4 sided cowbell is made of thick 1/4" steel plate. The trap can sit on a flat surface or be chained and hung from a tree. The targets are held one of 2 ways. The front frame can be installed and the targets slip into the frame slot, or the spring clip can be installed and the target is held by the spring clip. Both the front frame and spring clip are removable and held in place by heavy magnets. The front frame is made from 3 sections of heavy 1/8" steel flat stock.
The inside of this unit can be set up in a number of ways. There is a thick swinging rubber plate, A very heavy 1/2" thick steel swing plate or a very heavy 1/2" thick steel angled fixed plate. These plates should stop any airgun made today.
The heavy steel bottom section is bolted in place by thumb screws on each side. This makes it removable to clear the trap of smashed pellets. The press fit top is made from 2 sections of high density polyethylene, and is 1" thick. The top comes off to easily access the swing plates. This unit is solid and very heavy. All pieces combined weigh a whopping 60 pounds.
Approximate size is as follows:
Front is 12" X 12"
Depth is 16"
Height is 13"