Tactical Scorpion Gear AR500 Steel Shooting Range Target Lot of 4 3" x 1/4" Gong

Description

Tactical Scorpion Gear Laser Cut one Ar500 1/4" Shooting Target Gong
Tactical Scorpion Gear AR500 1/4″ steel shooting target
Two 1/2″ mounting holes ( With thick ears to take hits without breaking)
Hang from both holes for more stability but you can hang from a single hole
We utilize a Fiber laser cutting table for the cutting of all our AR500 products.
Plasma cutting cuts slowly, this puts a lot of heat into the steel. ( Submerged plasma cutting machine is no better) This excess heat can result in excessive chipping and damage near the cut edge during use and easily shattering when shot. Plasma cutting generates large amounts of heat that is deposited into the target, softening it’s edges. The
heat-affected zone
(HAZ) generated by plasma cutting is the largest out of the most commonly used methods for cutting abrasion resistant steel. Most AR500 is cut with plasma cutters as they are cheap and relatively small compared to other methods.
Superior Material : AR500 1/4″ steel
with 477 – 550 BHN
Minimum surface hardness of 477 BHN. Core hardness 450 min BHN
1/4” AR500 steel targets work great for the following calibers
.22 Rim Fire, 9mm, .38 Spl, .44 Spl, .45acp – 8 yards
.357, .40 SW, .44 mag – 12 yards
Shotgun w/ lead bird shot – 12 yards
Shotgun w/ std velocity 00 buck – 20 yards
Shotgun w/ std velocity slug -50 yards
.
For velocities over 3000fps MV use at 200 yards minimum. Handguns should be used no closer than 10 yards and rifles 100 yards.
All targets are raw and unfinished
All of our 1/4″ targets carry a limited lifetime guarantee from breakage